Yuri digital satellite finder, all dth signal meter price, and review, best satellite finder meter

85 / 100

Hi, friends today in This article we are going to read about this Yuri Digital satellite 📡 finder all dTH signal meter price, and technical specifications.

Where to use this meter?

This meter is mainly used for DTH technicians who want to get the Satellite signal for the DTH. With this meter, you can Easily Get Any type of DTH (Sundirect, Airtel, D2h, DishTV, etc) satellite signal Within less than 5 minutes.

Yuri satellite finder features

Digital meter for signal strength and quality

LNB short protect

Sound and Light Alarm for Locking Signal

Support mechanical compass

7.4V/2500mAh Li-Ion Battery Included

Auto Calculate Angle of AZ, EL

Supports DiSEqC 1.0/1.1, 0/22khz Tone

Beep Integrated

Software upgrade via USB port

Torch included

With 10 Indian regional languages

USB Short Protection

What inside the Box

User manual For How to operate this meter.

Carry bag

Charging adaptor 12v 1 amps

Carry belt. You can use this belt to Hang this meter in your neck or Wherever you want.

USB cable for Charging and software upgrade Related use.

Technical specifications

You can see the Above picture This meter Has two LNB signal inputs Along with an Inbuilt Torch. and also comes with an onboard Separate single strength display. It is very useful if you have any problem with this meter Display. If you already used this meter You can put your feedback in your comments section. If you want to know more about this yuri Digital satellite finder You can ask me in the comments section below.

How to get a signal from this meter

In this article, we are going to Get the signal from Airtel DTH.

Before you Do anything, first Set the dish facing the Southeast position.

First of all, loosen the all bolts and nuts To Rotate the dish Up and and down and Left and right to get the perfect Signal. When all is done check the Yuri meter if the Signal shows 60% or above you can lock the dish and tighten the bolts and nuts. Don’t fit the dish below 60 because it will affect the picture quality. After Connecting the Dish and yuri meter Turn on the Meter.

After Turning on the Meter you can Select which DTH you want to get the signal

After Selecting the DTH you can see strength and Quality Of the DTH Signal. Just slightly adjust the Dish To Increase the quality of the signal. This meter also comes with LNB Short circuit protection… if any problem with LNB The meter will Indicate the Fault. You can easily Find the problem and Fit The Dish at the correct position.

After Setting the right position the Meter will Start the alarm with a beep sound to confirm. If you don’t want the alarm sound you can simply Stop the sound in the Device settings. After all positions Done make sure to tighten all the bolts and nuts. And check the signal again to confirm.